QR Control Customizer (H5S)

As the HERO5 Session can’t scan while capturing, and the camera defaults to a QuickCapture, you have to enable the menu for scanning to occur. Boot the camera with the menu button, then press the menu button again when the screen turns on. The menu will function normally, but within a moment or two it will display “QR Ready”. The camera will remain on for 30 seconds, plenty of time to scan your QR Code.

Scanning Your Code

Scanning

Whether you scan a QR Code from a laptop screen or a mobile phone, the code should be a minimum 1.5”/40cm in size with the camera about 6”/15cm away. The larger the QR Code, the easier it is to scan. Point the camera at the center of the code, hold it still for about a second. Once scanned successfully it will display “Good Scan” and then double-beep. It will now be in the mode you have selected, and have exited the menu, ready for shooting. To power off, press the menu button (it will then shutdown in 30 seconds) or select “EXIT MENU” for an immediate shutdown.

Customize Your QR Code

Camera Mode: not set
Video Photo Timelapse Video

Lens: Wide Linear not set

Stabilization: Off On not set

Protune Controls

Protune Color: GoPro Flat not set

ISO Limit: 400 800 1600 not set

Sharpness: Low Medium High not set

Camera Preferences

Voice Control: off on not set

LEDs On: All Off Rear Only All On not set

WiFi Connections: Off On not set

Set date + time automatically

add 1/100th of a second

Delayed Actions

Shutdown after scanning this QR Code

Shutdown and capture in: hours mins secs
or at camera time: (format 24hr HH:MM)

End capture after: hours mins secs
or at camera time: (format 24hr HH:MM)

Repeat Command

Additional Commands:

GoPro QR Command:

Share this QR Code as a URL:

Learn more on QR Control

This Page as a Mobile App

Compatibility: Labs enabled HERO5 Session

ver 1.33

Learn more on QR Control